Telematics Remote Alerting
Detect vehicle fires and raise the alarm immediately, even when nobody is on site.
Detect Vehicle Fires Early in Depots and Yards and Alert by SMS
firedect’s remote fire alerting system consists of a telematics unit with LTE/GSM communication and rugged fire detectors (IP68). When a detector senses a fire, the system triggers an alert chain within seconds: by SMS, email, app push notification or to a control center. It works independently of the vehicle’s existing fire detection and suppression systems, needs no major intervention in the on-board electronics and can also be retrofitted to vehicles already in service.
Advantages
Alert chain within seconds
Alerts by SMS, email, app or control center
Runs in parallel with existing detection and suppression systems
Retrofit-ready for new and existing vehicles
Anwendungsbereiche
- Public transport depots and yards
- Bus company parking areas
- Haulage and logistics yards with truck fleets
- Municipal and service vehicle fleets
- Parking areas for special-purpose vehicles
Standards, Approvals and Key Data
- CE/RED
- UN/ECE R10
- Ingress protection IP54 (telematics unit) and IP68 (fire detectors)
- Fire detectors with 120 °C or 175 °C trigger temperature, automatic reset after temperature drop
FAQ
What is remote fire alerting for vehicles?
It is a system that detects a vehicle fire automatically and forwards the alert to defined recipients. With firedect, a telematics unit sends the alert by SMS, email, app or to a control center, while fire detectors monitor the temperature in the vehicle.
How fast is the alert, and who is notified?
Within seconds of the fire signal. The message goes out simultaneously to all stored recipient groups, e.g. operations management, workshop, control center or a fleet management system.
Can I install the system alongside an existing fire detection or suppression system?
Yes. It works as a stand-alone addition without interfering with existing safety concepts, e.g. alongside the fire detection control unit AF400 or a fire suppression system.
Can the system be retrofitted to vehicles already in service?
Yes. Installation takes little effort. Cable lengths and mounting are adapted to each vehicle, the detectors can be positioned freely, and the system can be expanded modularly with additional detectors.
What happens in case of a cable break or wiring fault?
The system monitors the detector line continuously. Line interruptions and wiring faults are detected and reported as a fault, rather than only being discovered in a fire.






